1. Welcome to Hvacproforums, an interactive community exclusively for HVAC professionals. The collective years of HVAC experience and the knowledge our forum members share make this an invaluable resource for those in the HVAC industry. We have a lot of fun, but make no mistake, we are pros. Hvacproforums is self supporting ...there are NO advertisers here. Do-it-yourselfers and Homeowners are encouraged to seek information elsewhere. Those involved in the HVAC industry are urged to register. its 100% free and easy, Once registered you will have access to the technical forums, Be sure to click over to the new members forum and introduce yourself after registering!

GenTeq X-13 Blower Motor Runs Continously

Discussion in 'Residential' started by Al Ferree, Dec 12, 2017.

  1. pecmsg

    pecmsg Junior my ASS

    Messages:
    21,714
    Location:
    Eastern LI
    I resemble that remark!
     
  2. 62subcool

    62subcool New Member

    Messages:
    4
    This is my two cents.

    Isolate the

    section from the troubleshooting .Make shure you are not getting feed back from your air handler.

    The x-13 motors are a new wrinkle in trouble shooting. They feed back a lot when they go out.
    Just because it runs do not mean it is not bad. I had one of these the other day that ran too. Isolate it and recheck.
    You might have a bad x-13 motor.
    This will isolate your troubleshooting area for you. This will tell you if the problem is in the air handler or thermostat wire going to thermostat or themostat. Go luck hope this helps.

    These motors do not have a run capacitor !
     
    Last edited: Dec 25, 2017
  3. Chuck

    Chuck SSP

    Messages:
    8,027
    Location:
    LAX
    You’re kidding right?
     
    jpb2 likes this.
  4. pecmsg

    pecmsg Junior my ASS

    Messages:
    21,714
    Location:
    Eastern LI
    Flux capacitors
     
  5. mike1020

    mike1020 entitled millennial

    Messages:
    18,541
    Location:
    on the roof of target
    And just who are you?
     
  6. mike1020

    mike1020 entitled millennial

    Messages:
    18,541
    Location:
    on the roof of target
    Do you mow your own grass?
     
  7. R2D2-TX

    R2D2-TX New Member

    Messages:
    486
    1.21 Gigawatts..
     
  8. Chuck

    Chuck SSP

    Messages:
    8,027
    Location:
    LAX
    If you have to ask, you don't need to know.
    Yes, except for when the john deere breaks down
     
  9. mike1020

    mike1020 entitled millennial

    Messages:
    18,541
    Location:
    on the roof of target
    You’re forgetting that I have a button
     
  10. HMD

    HMD does it matter?

    Messages:
    93,963
    Location:
    here
    well, pull the lint outta it and get your pantaloons back on